The selection and installation method of water clo

2022-07-22
  • Detail

Selection method: choose a toilet with a large caliber. The simplest detection method is to measure it by hand. A sewage pipe with the best palm capacity and glazed inner surface is not easy to hang dirty. The sewage is discharged quickly and effectively, which can effectively prevent blockage

selection method:

select the toilet with large caliber. The simplest detection method is to measure by hand. A sewage pipe with the best palm capacity and glazed inner surface is not easy to hang dirty. The sewage is discharged quickly and effectively, which can effectively prevent blockage

how to judge whether the toilet water storage tank is leaking? In addition to the obvious dripping sound, this normal situation is not easy to detect. The simplest inspection method is to drip colored ink into the toilet water tank, mix it well, and then see whether there is colored water flowing out of the toilet water outlet. If there is, it indicates that the toilet is leaking. Remind me, it's best to choose a higher water tank, so the impulse is very good

toilet flushing methods can be divided into “ Impact type &rdquo& ldquo; Siphon type ” And “ Siphon vortex ” Etc. The flushing type and siphon flushing type have strong sewage discharge capacity, but the sound is loud when flushing. The whirlpool type uses a lot of water at one time, but it has a good mute effect

in addition, attention should be paid to the glaze of the toilet. The glaze of the toilet with good quality should be smooth and smooth without blistering, and the color should be saturated. After inspecting the glaze of the outer surface, you should also touch the sewer of the toilet. If it is rough and unglazed, it is easy to hang dirt in the future

water parts directly determine the service life of the toilet. There is a great difference in the quality of water parts between brand toilets and ordinary toilets. The identification method is to listen to the sound of buttons. The water parts with crisp sound are of better quality

toilet installation method:

first decide where the toilet device is. First, align the sewage outlet at the bottom of the toilet with the air sewage pipe orifice. According to the peripheral size of the toilet base, judge and draw the position of the fixed toilet bottom corner eyelet, and drill with an impact drill. Generally, the hole depth is about 6cm

install the toilet base. Use the steel shrinkage bolt to knock into the air drilling, put the bottom corner of the toilet into the shrinkage bolt and tighten the nut to fix the toilet

step 3: install the water tank. (the one-piece toilet does not need to be equipped with a water tank) according to the position of the hole on the rear wall of the toilet box and the height of the water tank device, find out the corresponding position on the wall, fix it and drill holes, knock in the steel shrinkage bolt, fix the water tank in place, then put the wall hole into the shrinkage bolt, add 3mm thick nylon washer, put on the nut and tighten it

step 4: connect the pipe with the device. Of course, the connecting pipe between the water tank and the toilet base can be copper pipe or plastic pipe; The connecting pipe between the water pipe and the bottom of the water tank can use stainless steel bellows; An angle valve should be installed at the connection of the water inlet pipe, that is, the water inlet control valve

合肥性病医院

成都性病医院

沈阳男科医院

Copyright © 2011 JIN SHI